Compaq N160 manual Disconnect the fan cable from the system board 1 Figure

Models: N160

1 157
Download 157 pages 24.95 Kb
Page 84
Image 84
4.Disconnect the fan cable from the system board 1 (Figure 5-13).

Removal and Replacement Procedures

4.Disconnect the fan cable from the system board 1 (Figure 5-13).

5.Loosen the four silver M2.5 × 18 shoulder screws 2 that secure the fan assembly to the base enclosure.

The fan screws are spring-loaded and are captured by the fan assembly. Do not detach the fan screws from the fan assembly.

6.Lift up the right side 3 of the fan assembly until it clears the top cover shield.

7.Slide the fan assembly to the right at an angle 4 to remove it from the base enclosure.

Figure 5-13. Removing the Fan Assembly

Reverse the above procedure to install the fan assembly.

Maintenance and Service Guide

5–17

Page 84
Image 84
Compaq N160 manual Disconnect the fan cable from the system board 1 Figure