Compaq N160 manual Removing the System Board

Removal and Replacement Procedures

9.Press in and hold the PC Card eject button 1 (Figure 5-28).

10.Lift up the front edge of the system board 2 until it clears the base enclosure.

11.Slide the front edge of the system board forward, away from the base enclosure, at an angle 3.

Figure 5-28. Removing the System Board

Refer to the following sections to remove components from the system board:

■Memory expansion board (Section 5.4)

■Fan assembly (Section 5.8)

■Processor (Section 5.9)

■Disk cell RTC battery (Section 5.13)

■Mini PCI communications board (Section 5.14) Reverse the above procedure to install the system board.

Maintenance and Service Guide 5–39