Setting up workstations
NOTE: If the wrong software has been loaded on the client, the executable files may have the wrong extension. If this is the case, delete everything under the above directories.
If there are any files named print, listq, or listjob in the directories, /bin, or /usr/bin, delete them also.
Make sure that the DOS print command is not accidentally removed instead of the DocuPrint NPS/IPS print command. If you are not sure which command it is, type print <Enter>. The NPS/IPS command will always give a usage statement.
Setting up Macintosh workstations
This section describes the steps for installing the Xerox
Document Submission Client Software.
Preparing for installation
Before installing the software, make sure your computer has the following hardware and software:
•2 MB of Random Access Memory (RAM)
•A properly configured network card, or a bridge from LocalTalk to the network
•A
•A hard drive
•AppleShare version 2.0 or above
•System 8.6 or greater
•EtherTalk, version 1.0 or above
•Ethernet software that is associated with your Ethernet card
•Apple LaserWriter Driver, version 7.11 or higher. Version 8.0 or higher is recommended for use with PPD files, since earlier versions do not recognize PPD files.
NOTE: You cannot run the print job submission utility if you have the QuickDraw GX environment installed.
Guide to Submitting Jobs from the Client |
