Xerox 721P90350 manual

Printing using Xerox utilities and lpr utilities (DOS and UNIX)

•-C“(res=300)” for models 4050/4090/4850/4890/92C and 2060 only

-C“(res=600)” for 92C NPS/IPS

-C“(res=300)” or -C“(res=600)” for 96/4635/180 NPS/IPS Specifies the resolution in dots per inch (dpi).

•-C“(sg=<n>)”

Sets the OutputBin attribute to the integer value.

–sg=0 selects stacker group 0 (top tray).

–sg=1 selects stacker group 1.

–sg=2 selects stacker group 2.

NOTE: For more information on the OutputBin attribute, refer to the Guide to Managing Print Jobs, “Document attributes” chapter, “Attributes and values” section.

•-C“(<simplexduplextumble>)”

Specifies simplex, duplex, or tumble duplex for the print job. The default is “simplex.”

Tumble duplex rotates the image 180 degrees on alternate pages. Both sides of the page are printed but the position of the image is reversed (from top to bottom) on every other page.

NOTE: The use of tumble duplex is restricted by certain characteristics of the PostScript master. If you have difficulty using this option, contact your Xerox representative for assistance.

•-C“(size = <n>)”

Specifies the font size in points. This option is valid for ASCII jobs only.

•-C“(<stitchstaple>)” (for models 4050/4090/4850/4890/92C only)

Staples the document after it is printed. You can enter either “stitch” or “staple” to indicate the document is stapled.

Before using this option, verify that the printer to which you send your document has a stitcher/stacker installed.

Guide to Submitting Jobs from the Client 3-27