Xerox 721P90350 manual

Printing using Xerox utilities and lpr utilities (DOS and UNIX)

•-C“(bf=<background form>)”

Specifies the name of saved G4 form(s) created using decomposition services.

•-C“(cf=<n>)”

For a single multi-page Background Form associated with a document, allows you to specify how to cycle through pages when you run out of background images before the end of a document.

The Background Form that will be cycled can be specified in the same command line: -C“(bf=<formname>,cf=<n>)”.

•-C“(collated)”

Specifies that copies of the job are printed collated. This is the default behavior.

•-C“(copies=n)”

Specifies the number of copies of each file you want to print.

•-C“(disposition=<savemaskG4 savemaskBC saveformG4 saveformBC>)”

Sets a virtual printer for decomposition services.

•-C“(drilled)”

Sets the paper type to “drilled.” To use this option, the paper type at the printer controller must be set to “drilled” using the Set Tray command.

•-C”(eh)”

Sets the ElideHeader attribute to TRUE.

NOTE: This option acts the same as the -h lpr switch. However, for some implementations the -C flag interferes with the -h flag, therefore a -C option is needed.

•-C”(flip)”

Specifies that sheets are to be turned (flipped) over by the printer before delivering the sheets to the stacker.

•-C“(font=<font>)”

Specifies the font you want to use. You can specify any of the fonts installed on the printer controller. This option is valid for ASCII jobs only.

Guide to Submitting Jobs from the Client 3-21