Cleanup
Cleanup
1.Relieve Pressure, page 10.
2.Remove guard and Spray Tip. For additional infor- mation, see separate gun manual.
ti2769a
3.Remove siphon tube set from paint. Wipe excess paint off outside of tubes.
5. Turn prime valve horizontal.
ti22221a
6.Hold gun against paint pail. Disengage trigger lock. Trigger gun and increase pressure until the pump runs steady and flushing fluid appears.
1/4 Turn
Paint | ti22223a |
|
TIA
4.Place siphon tube in flushing fluid. Use water for water base paint and mineral spirits for oil base paint. Place drain tube in waste pail.
Flush
ti2756b
Waste
7.Stop triggering gun. Move gun to waste pail, hold gun against pail, trigger gun to thoroughly flush sys- tem.
ti2599ab
8.While continuing to trigger gun, turn prime valve down. Then, release gun trigger. Allow flushing fluid to circulate until fluid coming out of drain tube is clear.
ti22220a
16 | 332758A |
