7.3 Using LATCH to install Base

1.For ease of installation, extend LATCH to its maximum length

and remove from storage bars.

2. Position base in vehicle seat as shown.

3.Make sure LATCH is through vehicle/LATCH belt path normally used for vehicle seat belt. .

Belt must lay flat and not be twisted.

4.

Hook Connectors to vehicle lower

 

anchors. Pull firmly on Connectors to

 

be sure they are attached .

5.

Tighten LATCH by pushing down

 

hard on base and pulling the

 

adjustment belt .

6.

NEVER put two LATCH connectors

 

on one vehicle LATCH anchor unless

 

specifically allowed by the vehicle

 

manufacturer .

7.

Test infant restraint for secure

 

installation as described in infant

 

restraint “Final Safety Check” page.40.

8.Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another

seating position or contact Graco at 1-800-345-4109.

37

Page 36 Page 38
Page 37
Image 37
Graco Infant Restraint/Carrier manual Belt must lay flat and not be twisted
Page 36 Page 38
Top Page Image Contents