Graco ISPC094CB owner manual Installing the Infant Restraint and Base Using Vehicle Belt

Models: ISPC094CB

1 88
Download 88 pages 41.92 Kb
Page 34
Image 34

3. Buckle the vehicle belt. Make sure the buckle

 

tongue goes into the correct buckle . The

 

seat belt should not be twisted or turned.

 

 

4. Tighten the vehicle seat belt. Refer to your

 

 

vehicle owner’s manual and the instructions in “6.2.2 SAFE Vehicle

Belt Systems”, page.29-31, on tightening your vehicle belt when

using the infant restraint without base.

 

To create a secure installation, push down

 

hard with your free hand on the infant

 

restraint and pull and tighten the

 

 

vehicle belt.

 

 

5. Test infant restraint for secure installation

 

 

as described in infant restraint “Final Safety

 

 

Check” page.40.

 

 

7.2 Installing the Infant Restraint and Base

 

Using Vehicle Belt

 

 

When using the base to install the infant

 

 

restraint, the lock-off is ALWAYS used to

 

 

secure both belts of the lap or lap/shoulder

 

 

belt.

Lock-off

1. Place the base in a rear-facing position

on a vehicle seat.

 

2. Open the lock-off and route the vehicle

 

 

belt through the belt path and over the

 

 

lock-off.

 

 

34

Page 34
Image 34
Graco ISPC094CB Installing the Infant Restraint and Base Using Vehicle Belt, Seat belt should not be twisted or turned