7.3 Using UAS (Universal Anchorage System) to install Base | ||
1. | For ease of installation, extend | ➋ |
| UAS to its maximum length |
|
2. | and remove from storage bars. |
|
Position base in vehicle seat as shown. |
| |
3. | Make sure UAS is through |
|
| vehicle/UAS belt path normally |
|
| used for vehicle seat belt. ➋. | ➌ |
4. | Belt must lay flat and not be twisted. | |
Hook Connectors to vehicle lower |
| |
| anchors. Pull firmly on Connectors to |
|
5. | be sure they are attached ➌. |
|
Tighten UAS by pushing down |
| |
| hard on base and pulling the | ➍ |
6. | adjustment belt ➍. | |
NEVER put two UAS connectors |
| |
| on one vehicle UAS anchor unless |
|
| specifically allowed by the vehicle |
|
7. | manufacturer ➎. | ➎ |
Test infant restraint for secure | ||
| installation as described in infant |
|
8. | restraint “Final Safety Check” page.40. |
|
Check that the UAS stays tight |
| |
| and does not slip from the tightened |
|
| position. If it does not stay tight, try another |
|
| seating position or contact Elfe at |
|
37
