Belt should not be twisted or turned | Graco PD108602A, 1753039

3. Buckle the vehicle belt. Make sure the buckle tongue goes into the correct buckle ➊. The seat

belt should not be twisted or turned.

➊

4. Tighten the vehicle seat belt. Refer to your
vehicle ownerÊs manual and the instructions in „6.2.2	SAFE Vehicle
Belt Systems‰ , page.29-31, on tightening your vehicle belt when
using the infant restraint without base.	➋
To create a secure installation, push down
hard with your free hand on the infant
restraint ➋ and pull and tighten the
vehicle belt.

5. Test infant restraint for secure installation as described in infant restraint „Fina l Safety Check‰ page.40.

When using the base to install the infant
restraint, the lock-off is ALWAYSused to
secure both belts of the lap or lap/shoulder
belt.	Lock-off	➌
1. Place the base in a rear-facing position	Lock-off
1. Place the base in a rear-facing position
on a vehicle seat.

2. Open the lock-off and route the vehicle belt through the belt path and over the lock-off. ➌