Graco PD156938B owner manual FORWARD-FACING Installation with Vehicle Seat Belts

FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS

WARNING

LATCH belts MUST be stored when using vehicle seat belt to install child restraint.

1Store Rear Facing and Forward Facing LATCH belt as shown. (fig. a).

Adjust car seat to upright position

Flip recline feet out for forward facing use (fig. b).

2Place forward-facingon vehicle seat. Slide child restraint back until the restraint is in contact with the vehicle

seat back.

3Thread vehicle seat belt through openings and buckle belt (fig. c).

4Press down firmly in center of child restraint to compress vehicle seat

cushion while tightening vehicle seat belt (fig. d).

5Pull front to back and left to right at belt path to check for secure installation (fig. e). Vehicle lap belt

MUST stay tight. If not secure, see “Vehicle Seat Belts” pg. 38.

6Attach tether strap hook (A) to anchor hardware (B) and tighten adjustment belt to remove any slack (fig. f) . If vehicle does not have anchor points to attach tether hook, tether hook should be stored, see “Tether Storage”, page 47. Belt must lay flat and not be twisted.

Periodically check that child restraint is securely installed; adjust if necessary.

To remove LATCH, (see “Removing LATCH

from Vehicle Anchor Points”, p. 36).