Barrel Removal
1.Prepare the gun for service, page 26.
2.Carefully loosen the nut (C) from the bracket fluid fitting (13). See Fig. 15.
3.Loosen the three screws (11).
CAUTION
To avoid damaging the power supply (18), pull the gun barrel straight away from the gun handle. If nec- essary, gently move the gun barrel from side to side to free it from the gun handle.
4.Hold the gun handle (17) with one hand and pull the barrel (16) straight off the handle.
13 C
11
16
Repair
2.Place the barrel (16) over the power supply (18) and onto the gun handle (17).
3.Tighten the three screws (11) oppositely and evenly (about a half turn past snug).
CAUTION
Do not
4.Make sure the fluid filter (1) is in place in the fluid fitting. Tighten the bottom fluid tube nut (C) onto the bracket (13) fluid fitting and torque to
CAUTION
Be sure the fluid tube (14) is not twisted after tighten- ing the bottom nut (C).
5.Test gun resistance, page 19.
TI1516A
18
*10
11
16
17
17
ti1517a
Fig. 15. Barrel Removal
Barrel Installation
1.Be sure the gasket (10*, Fig. 16) and grounding spring (55, Fig. 13) are in place and the gasket air holes are aligned properly. Replace if damaged.
|
| 13 |
| 1 | TI1520B |
|
| |
14 |
| C |
Fig. 16. Barrel Installation
32 | 309295 |
