Graco Inc 233716 Bearing Housing and Connecting Rod, Removal, Installation, Model 233701 shown

Bearing Housing and Connecting Rod

NOTE: The item numbers referenced are for the Hi-Boy models. The Lo-Boy models may have different item numbers. Use the Hi-Boy item number and part to find the corresponding Lo-Boy part and item number.

Removal

1.

Relieve pressure; page 5.

2.Fig. 2. Remove screws (14) and front cover (23).

3.For Hi-Boy models; remove spring clip (32) and drain hose (54). Unscrew suction tube (30) from pump, hold wrench on pump intake valve (A) to keep pump from loosening. For Lo-Boy models; unscrew swivel union (30aa) from pump.

4.Disconnect pump outlet hose (33) from displace- ment pump outlet nipple (62).

5.Fig. 1. Use screwdriver to push up retaining spring (26) at top of pump. Push out pin (29).

29

Fig. 1	26
	7675B

6.Fig. 2. Loosen retaining nut (34). Unscrew and remove displacement pump (28).

7.Remove four screws (13) and lockwashers (12) from bearing housing (21).

8.Pull connecting rod (22) and lightly tap lower rear of bearing housing (21) with plastic mallet to loosen from drive housing (20). Pull bearing hous- ing and connecting rod assembly (22) off drive housing.

9.Inspect crank (B) for excessive wear and replace parts as needed.

Installation

1.Evenly lubricate inside of bronze bearing (C) in bearing housing (21) with high-quality motor oil. Liberally pack top roller bearing (E), lower bearing

(D) inside connecting rod assembly (22) with bearing grease.

8 309409

2.Assemble connecting rod (22) and bearing housing (21).

3.Clean mating surfaces of bearing and drive hous- ings.

4.Align connecting rod with crank (B) and carefully align locating pins (F) in drive housing (20) with holes in bearing housing (21). Push bearing hous- ing onto drive housing or tap into place with plastic mallet.

CAUTION

DO NOT use bearing housing screws (13) to align or seat bearing housing with drive housing. Align these parts with locating pins (F), to avoid prema- ture bearing wear.

5.Install screws (13) and lockwashers (12) on bear- ing housing. Torque evenly to note 3 value in Fig. 2.

6.Refer to Displacement Pump, Installation, page 17.

1 C	E 2
	2

D
22	12, 13	3

23

B

20

F 26	14
	32

29

33

62

34	21
28

A	54
30

1Oil

8697B

2Pack with bearing grease 114819

3GMax 3900: Torque to 200 in-lb (22.6 N￿m)

GMax 5900: Torque to 25 ft-lb (34 N￿m)

8697A

Fig. 2 Model 233701 shown