SERVICE
Gun Disassembly | 3 | Install the new electrode 2 with the wrench 59c | |||||
6WARNING5 |
|
| supplied Do not overtighten | ||||
|
|
|
|
|
| ||
Installing and servicing this equipment requires |
| CAUTION |
|
| |||
access to parts which may cause electric shock |
|
|
| ||||
|
|
|
|
| |||
or other serious bodily injury if the work is not per4 To avoid damaging the plastic threads be very | |||||||
formed properly Do not install or service this |
| careful when installing the electrode | |||||
|
|
|
|
| |||
equipment unless you are trained and qualified | 4 | Reinstall fluid nozzle and air cap assembly as | |||||
Follow thePressure Relief Procedure Warning, | |||||||
| described inClean | the Air Cap and FluidNozzle | |||||
page 9 before servicing the gun or any part of the | |||||||
system Disconnect the fluid hose from the gun |
|
|
|
|
| ||
KEY
45Fluid Needle Shaft Assembly
59c Wrench | 59c |
|
NOTE: Check all possible remedies in the Troubleshooting Charts before disassembling the gun
CAUTION
If the plastic parts of the gun must be held se4 45 curely ALWAYS clamp them in padded vice jaws
to prevent damage to the parts
ALWAYS lubricate orings and seals with petro4 leum jelly
ALWAYS remove gun from worksite for service or repair Service or repair area must be clean
Flush the gun as described underFlush the Spray
Gun. Follow thePressure Relief Procedure Warning
on page 9 Disconnect the air and fluid line from thegun
Electrode Replacement
Remove the air cap assembly and fluid nozzle as de4 scribed inClean the Air Cap and FluidNozzle
Fig 10
2 Unscrew and remove the electrode 2 with the wrench 59c supplied See Fig If the needle shaft assembly 45 turns while trying to loosen the electrode hold the needle shaft assembly nut with a small wrench
18
