STARTUP
Always usethis start upprocedureto ensure that the unit | Trigger Safety Latch |
is started safely and properly. | WARNING |
1. Checkthe oil level. | To reduce the risk of serious bodily injury, |
Pump: Add SAE XI or 30 weight | includingfluid injection, splashinginthe eyesor |
on the skin,ALWAYS engage the trigger safety | |
as necessary. | latch whenever spraying stops, evenfora |
| moment. |
2. Tum on the watersupply. |
|
|
| |
CAUTION | ||||
|
|
| Inthe engaged position, the trigger safetylatch | |
|
|
| preventsthegunfrom | being triggered |
Never run the unit dry. Costly damage to the | accidentally by hand or ifit | is dropped or | ||
pump will | result.Always be sure the water | bumped. Be sure thelatch is pushedfully down | ||
supply is | completelytumed | on before | when engaging it or it cannot prevent the gun | |
operating. |
|
| from being triggered. See Figure 2. | |
|
|
|
| |
3. Triggerthegun until waterspraysfromthe tip indicatingthat the air is purgedfrom the system.
4.Plugtheelectrical cord into proper,grounded,
5.ALWAYS engagethegun’striggersafety latch whenever you stop spraying, even for a momentto reduce the riskof fluid injection or splashing in the eyes or on the skinif the gunis bumpedor triggered accidentally.
6.ALWAYS observethe following CAUTIONS toavoid
costly damage to the pressure washer. | TRIGGER SAFETY LATCH SHOWN ENGAGED |
CAUTION
DO NOT allow the pressure washerto idle for more than10 minutes. Doingso may causethe recircuiating water lo overheat and seriously damage the pumpTum. off the pressure washer if it will notDe sprayingor cleaningat leastevery
10 minutes. If heated inlet wateris used, reduce this timefurther.
DO NOT run the pump dry, which will quickly damage the pumpBe. sure the watersupply is fully tumed on before starting the pump.
DO NOT operate the pressure washer with the inlet water screen removed. This screen helps keep abrasivesediment out of the pump, which could clog or scratchthepump,Keepthis screen clean.
DO NOT pump caustic materiais;such materials may corrodethe pump components.
7. See the chemical injectoror sandblasterkit manual for detailed cleaninginformationifthese accessories are used.
TRIGGER SAFETY LATCHSHOWN DISENGAGED
