Operation
DD
0365
45 43c
26
43g 31
1
20
0369A
Fig. 4
Selecting a Fluid Nozzle and Air Cap
WARNING
PRESSURIZED EQUIPMENT HAZARD
To reduce the risk of an injury, follow the Pressure Relief Procedure on page 11 before removing or installing a fluid nozzle and/or air cap.
The gun is supplied with a 0.059 in. (1.5 mm) fluid nozzle, P/N 185158, and air cap, P/N 193033. If your application requires a different nozzle and air cap combination, use instruction manual 307803 or consult your authorized Graco distributor to select the ap- propriate fluid nozzle and air cap. Install the air cap and fluid nozzle into the gun barrel as instructed in Air Cap/Nozzle/Resistor Stud Replacement, page 22.
Operating the Spray Gun
WARNING
PRESSURIZED EQUIPMENT HAZARD
To reduce the risk of an injury, follow the Pressure Relief Procedure on page 11 whenever you stop spraying and whenever you are instructed to relieve pressure.
WARNING
COMPONENT RUPTURE HAZARD
To reduce the risk of component rupture, which can cause serious injury, do not
exceed the maximum working pressure of the lowest rated system component. This equip- ment has a 100 psi (7 bar, 0.7 MPa) maximum working air and fluid pressure.
Follow the steps on page 13 to establish the correct fluid flow and air flow. Do not turn the ES
12 308131
