Models, G40 Standard Spray Gun, 288046, Series a | Graco Inc

Models

Models

A manifold is required for each gun to be installed. Refer to the Parts section for manifold information.

G40 Standard Spray Gun, 288046, Series A

•High pressure spray gun with Carbide ball and Car- bide seat.

•Includes AAP series tip of choice.

G40 Plastic Seat Spray Gun, 288044, Series B

•Medium pressure spray gun with SST ball and plas- tic seat; for acid catalyzed or thin fluids.

•Best results when used with non-abrasive fluids at pressures below 1500 psi (10.5 MPa,105 bar).

•Includes AAP series tip of choice.

G40 RAC Spray Gun, 288053, Series A

•High pressure spray gun with AA Reverse-A-Clean (RAC) assembly; and Carbide ball and Carbide Seat.

•Includes LTX Series RAC tip of choice.

311052E

3

Image 3

Graco Inc 311052E Models, G40 Standard Spray Gun, 288046, Series a, G40 Plastic Seat Spray Gun, 288044, Series B

Contents

Automatic G40 Air-Assisted Spray Guns Related Manuals Contents G40 RAC Spray Gun, 288053, Series a ModelsG40 Standard Spray Gun, 288046, Series a G40 Plastic Seat Spray Gun, 288044, Series B Equipment Misuse Hazard Pressurized Equipment Hazard Circulating System InstallationVentilate Spray Booth Configure Gun and Manifold Ground System Install Air Fittings Retrofit Adapter Plate Mount GunReciprocating Arm Rod Mount Stationary Support Connect Air Line Side Mounted Manifold Ports Connect Fluid Line Setup Pressure Relief Procedure Adjust Spray PatternOperation No air Too little air Correct amount Air Apply FluidIncorrect Correct Daily Gun Care Maintenance Flushing and Cleaning General System Maintenance Turn off the solvent supply Troubleshooting General TroubleshootingProblem Cause Solution Problem Cause Solution Spray Pattern Troubleshooting Service DisassemblyItems Needed for Service TI8173b Cutaway View Part No Gun Shown Reassembly Diffuser Seat Replacement Parts AA RAC Assembly included with Model 288053 only Part Ref. No. No Description Qty Parts North America and International Manifold Description Qty Manifold with Bottom Fluid Ports Part No. Description Qty Part No C343 Side Fluid Ports and Fan Adjustment Valve RING, Ptfe 311052E AAP Series Tip and Air Cap Selection Charts AAP Series Precision Spray TipsTypical Air Application Tip Used With Consumption LTX Series RAC Tip Selection Charts For use with G40 RAC HousingLTX Reverse-A-Clean RAC Spray Tips RAC Switch Tips FFT Fine Finish RAC Spray TipsWRX Wide RAC Spray Tips Accessories Plastic Seat Repair Kit Ultimate Gun Cleaning Kit 15C161Grounding Clamp and Wire In-line Fluid Filter Air Cap Seal Kit Dimensions Mounting Hole Layout Gun with Rear Port Manifold Rear Port Manifold Models 3/16 in. ball Cylinder Air Pressure Fluid Pressure Technical DataTriggering Speed Sound Data dBa Graco Information Graco Standard Warranty