Installation
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod [0.5 in. (13 mm) diameter maximum]:
1.Insert the mounting bar (A) through the hole in the manifold as shown in FIG. 3.
Use the 1/8 in. alignment pin (P) to assist in orient- ing the gun.
2.Secure the gun to the bar by tightening the mount- ing screw (B).
B
P
A | TI8120a |
FIG. 3: Reciprocating Arm Mount
Stationary Support
To mount the gun on a stationary support (refer to FIG.
4.and to Mounting Hole Layout, page 37):
1.Align the manifold with the alignment pins. Locate alignment pins and holes per the Mounting Hole Layout illustration, page 37.
2.Secure the gun to the support with two M5 x 0.8 capscrews (S). The screws must be long enough to engage the threaded holes in the gun manifold to a depth of 1/4 in. (6 mm).
TI8121a
S
FIG. 4: Stationary Support Mount
Retrofit Adapter Plate
The retrofit adapter plate enables the manifold to be attached to a variety of bolt patterns.
To mount the gun using the retrofit adapter plate (kit 288197):
1.Mount adapter plate to manifold using the three screws provided with the kit (FIG. 5).
2.Bolt plate to mounting surface using four M5 x 0.8 capscrews. Refer to the Mounting Hole Layout, page 37.
FIG. 5: Retrofit Adapter Plate | TI8180a |
| |
|
|
8 | 311052E |
