Mount Gun, Reciprocating Arm Rod Mount | Graco Inc 313516C specification

Installation

Mount Gun

Reciprocating Arm Rod Mount

To mount the gun on a reciprocating arm rod

[0.5 in. (13 mm) diameter maximum]:

1.Insert the mounting bar (A) through the hole in the manifold as shown in FIG. 3.

NOTE: Use the 1/8 in. alignment pin (P) to assist in orienting the gun.

2.Secure the gun to the bar by tightening the mounting screw (B).

B

P

A

ti13587a

FIG. 3: Reciprocating Arm Mount

Stationary Support

To mount the gun on a stationary support (refer to FIG. 4 and to the correct mounting hole layout for your manifold, pages 38-42):

1.Align the manifold with the alignment pins. Locate alignment pins and holes per the mounting hole layout.

2.Secure the gun to the support with two M5 x 0.8 capscrews (C). The screws must be long enough to engage the threaded holes in the gun manifold to a depth of 1/4 in.

(6 mm).

C

ti13588a

FIG. 4: Stationary Support Mount

12

313516C

Image 12

Graco Inc 313516C important safety instructions Mount Gun, Reciprocating Arm Rod Mount, Stationary Support

Contents

Important Safety Instructions Automatic AirPro Spray Guns Contents Models Fire and Explosion Hazard Pressurized Equipment Hazard Selection Charts General Metal Applications High Wear Applications Wood ApplicationsGun Selection Hvlp Guns Proper Needle/Nozzle Selection Air CapsConventional Guns Air Flow Atomizing Air Fan AirAir Flow Maximum HVLP/Compliant inlet manifold pressure Installation Ventilate Spray BoothConfigure Gun and Manifold Circulating System Install Air Fittings Ground System Mount Gun Reciprocating Arm Rod MountStationary Support Retrofit Adapter Plate Retrofit Adapter Plate Mount Setup Connect Air LineConnect Fluid Hose Flush Spray Gun Position Air Cap Adjust Spray Pattern Suggested Starting Settings AtomizationFan Air psi Spray Gun Air Pressure Regulator Pressure Relief Procedure OperationApply Fluid Incorrect Daily Gun Care General System Maintenance Clean and Flush Gun Troubleshooting General TroubleshootingProblem Cause Solution Spray Pattern Troubleshooting Service Disassembly Alternate Fluid Control Shown Reassembly Parts 17† 21† Alternate Fluid Control 20† 22† 36† 24a 25a Gasket Repair Kits General Metal ApplicationsNozzle High Wear Applications Wood Applications Manifold with bottom fluid ports Part Description Qty Side Fluid Ports and Fan Adjustment Valve Part No C342 Description Qty Not shown, optional size Not sold separately Part No only 106 Accessories Hvlp Pressure Verification Kit Inline Fluid Filter 24B707Spray Tip Filters Count Carton Pack Description Dimensions Manifold Models 288217 or 288218, All Gun ModelsManifold Model 288221, All Gun Models Manifold Model 288223 or 24C342, All Gun Models Manifold Model 288160 or 288211, All Gun Models Mounting Hole Layouts 23.4 mm 10.2 mm 53.3 mm 50 in .7 mm Mounting hole 216 23.4 mm 10.2 mm 27.9 mm 375 in .5 mm Mounting hole Retrofit Adapter Plate Technical Data Triggering SpeedSound Data Cylinder Air Fluid Pressure Air Pressure Msec to fully Graco Standard Warranty Graco InformationGraco Headquarters Minneapolis