CONFIGURATION GUIDE
This section of the BT200 manual will help guide you to configure your phone, either using the keypad or through the web interface. Examples of the web interfaces can be downloaded @ http://www.grandstream.com/user_manuals/GUI/GUI_BT200.rar.
CONFIGURATION WITH KEYPAD
Configuring the BT200 using the key pad is simple. If at anytime the phone rings or there is a 20+ second idle time, while in the configuration state, the phone will exit the configuration menu. You can answer an incoming call as usual during the configuration stage.
First, be sure your phone is not in use. Press the MENU button to enter key pad menu. There are eleven main menu functions ranging from 1 – 11. Navigate the menu options using the navigation keys on the keypad.
TABLE 7: CONFIGURATION MENU DEFINITIONS
Menu Item Menu Functions
Display “[1] dhcP On ” or “[1] dhcP oFF” for the current selection
Press MENU key to enter edit mode
1Press ‘↓’ or ’↑’ to toggle the selection Press MENU to save and exit
Must recycle power for changes to take effect.
Display “[2] IP Addr ”
Press MENU to display the current IP address
|
|
| Enter new IP address if DHCP is OFF | |
| 2 | |||
|
| Press ‘↓’ or ’↑’ to exit | ||
|
|
| ||
|
|
| Press MENU to (save and) exit | |
|
|
| Must recycle power for changes to take effect. | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Display “[3] SubNet ” |
|
|
|
| Press MENU to display the Subnet mask |
|
| 3 |
| Enter new Subnet mask if DHCP is OFF |
|
|
| Press ‘↓’ or ’↑’ to exit |
| |
|
|
|
| |
|
|
| Press MENU to (save and) exit |
|
|
|
| Must recycle power for changes to take effect. |
|
|
|
|
|
|
|
|
|
|
|
Display “[4] routEr ”
Press MENU to display the Router/Gateway address
Enter new Router/Gateway address if DHCP is OFF
4Press ‘↓’ or ’↑’ to exit
Press MENU to (save and) exit
Must recycle power for changes to take effect.
Grandstream Networks, Inc. | BT200 User Manual | Page 16 of 37 |
| Firmware 1.1.1.14 | Last Updated: 12/2006 |
