Periodic Inspection
1)Check the CO2 tank pressure gauge on the cylinder regulator assembly. Replace if tank pressure drops below red line.
2)Make sure the unit contains a sufficient supply of syrup and alcohol.
3)Check to see that there is sufficient air space on both sides of the unit. Proper air circulation is required for efficient operation. Make sure that the louvers are not obstructed at any time. CAUTION: Failure to provide minimum air flow clearance will void the freezer warranty. (See Locating Freezer)
Freezer Assembly and Installation
Attaching Freezer to Base Cart
1)Unbox freezer (top half)
a)Remove both side panels and then use a 7/16” socket to remove the 2 bolts at the bottom of the freezer that hold it to the shipping pallet.
b)Cut the wire tie (note red tag) on freezer drive motor. (Figure 2)
c)Leave right side panel (when facing front of freezer) off.
2)Place a bead of silicone sealant all the way around the edge of the base cart top. (See Figure 3)
3)Place beverage freezer onto the base cabinet on top of the bead of silicone. Position freezer over mounting holes before sealant sets. (Figure 4)
4) Secure top half of unit to base cart by installing 7/16" bolts and nuts using the same holes used to secure the freezer to shipping pallet.
5)Open rear door of base cabinet and place black plastic bushing in wire hole in the top of the cabinet.
6)Feed the
CAUTION: Do not leave too much slack in the wires as they could get caught in the fan blades. Use wire tie and holder to secure wires in place. See electrical diagram.
7)Remove the base cart electrical box cover (located in the upper right corner of the base cart). Feed the power cord (found inside lower rear right side of freezer, near the terminals)
through hole into the base cart and then feed it into the hole in the rear of the electrical box. Connect power cord wires. (See Addendum 3 and 4)
8)Route the product feed tubing (located in the freezer) down through hole into base cabinet. Route the tubing to the top part of the freezer following the same path as the wiring.
9)Attach the tubing to the John Guest 90° elbow fitting which is located in the base cabinet behind the electrical box. Make certain that the tubing is pushed all the way into the fitting. (Figure 5)
10)Replace freezer side panels.
11)Turn "on/off/clean" switch on front of unit to the OFF position.
90° Support 
Product Feed Tubing
Figure 5
Figure 4
Page 4 | Crathco Beverage Freezers |
|
|
