Operation
!CAUTION: HOT LIQUID HAZARD
WATER USED FOR BREWING TEA IS VERY HOT. USE CAUTION WHEN BREWING, POURING OR TRANSPORTING HOT TEA. NEVER ATTEMPT TO MOVE THE BREWER WITHOUT FIRST DRAINING THE WATER TANK. ACCIDENTAL SPILLS MAY RESULT IN SEVERE BURNS.
1.Place an empty tea dispenser on the base of the tea brewer. The placement should allow the bypass and the brew basket drain to empty into the container.
2.Remove the brew basket and line it with a paper filter. Paper size is 13" x 5" (Filter #BB1.5WP).
3.Place tealeaves in the filter basket. Your tea supplier can help you select the right amount of tea to use. Tea experts recommend 1 oz. (28 g) of loose tea for each gallon (3.8 litre) of finished product.
4.Slide the basket into the brewer, making sure the basket is pushed completely back. In the proper position the basket and the dispenser are pushed back onto the brewer.
5.Check that the Water Hot light is illuminated. If not then wait for the water to reach proper brewing temperature and the light will turn on.
6.Press the Start switch to start the cycle. Total brew time is dependent upon brewer settings.
!
CAUTION: HOT LIQUID HAZARD
TEA BASKET CONTAINS VERY HOT LIQUID UNTIL THE
7.During the brewing process the hot tea is mixed with cold water in the dispenser. Add sweetener if desired and serve over ice.
8.After brewing place the cover over the tea dispenser to keep fresh.
9.Dump the used tea and filter from the basket and rinse for the next brew.
Adjustments
!
WARNING: ELECTRIC SHOCK HAZARD
DANGEROUS ELECTRIC VOLTAGES ARE PRESENT NEAR ADJUSTABLE COMPONENTS. ONLY QUALIFIED SERVICE PERSONNEL SHOULD MAKE ADJUSTMENTS.
All adjustable components are located under the top cover or behind the lower front cover.
Timer Adjustment
Change timer setting if the total volume of dispensed liquid requires adjustment.
1.Shut off power and unplug the brewer.
2.Remove the screw fastening the top cover. Remove the top cover by pulling forward and lifting upwards.
Figure A
American Metal Ware® Tea Brewers | Page 5 |
