Conveyor Belt |
|
Replacement |
|
Tools Needed: | Qty |
Hex Wrench 6mm | 1 |
Wrench/Socket 19mm | 1 |
Wrenches/Sockets 14mm | 2 |
Wrench/Socket 12mm | 1 |
Wrench 10mm | 1 |
Phillips Head Screwdriver #2 | 1 |
Measuring Tape | 1 |
Gauge Blocks (see Page 30) | 2 |
Feeler Gauge Set | 1 |
Assistant for Lifting Help | 1 |
Flashlight or Work Light | 1 |
Correction Fluid or Paint | 1 |
Black Felt Tipped Pen | 1 |
Replacing the conveyor belt is a big job and requires moderate mechanical skill and a fair amount of patience. For planning purposes, expect to have your machine out of operation for at least a few hours.
As you remove hardware to complete these instructions, we recommend putting all the bolts, screws, washers, etc. back into the holes from which they came. This simple habit will take slight- ly longer when disassembling the machine, but it will save you a lot of time and reduce frustration during reassembly.
To replace the conveyor belt:
1.DISCONNECT POWER TO THE SANDER!
2.Remove the top cover by loosening the hex bolts and removing the Phillips head screws (Figure 40) securing the top cover support.
NEW
PHOTO
Figure 40. Locations to remove top cover
mounting hardware.
3.Remove the right handle and side panel (2 cap screws and 6 tap screws).
4.Remove the gear cover (2 Phillips head screws) and loosen the 2 hex nuts securing the brace and remove it.
5.Remove the dust scoop (4 hex bolts and 4 flat washers), compression springs and spring plates (Figure 41) from the front pres- sure roller and set the roller aside.
Spring |
Plate |
Compression |
Spring |
Figure 41. Front pressure roller components.
Model G0459/G0459P (Mfg. 7/11+) |
