Grizzly G0460/G0461 owner manual Main Blade, To install the blade

Main Blade
Components and Hardware Needed:	Qty
Blade 12" (Not Included)	1
Riving Knife	1
To install the blade:

1.DISCONNECT SAW FROM POWER!

2.Open the cabinet and remove the red motor support bolt, shown in Figure 23, by remov- ing the nut and tilting the blade assembly to clear the bolt.

Figure 23. Motor support shipping bolt.

3.Move the blade tilt to 0° (blade 90° to table) and raise the main blade arbor.

4.Slide the table all the way forward to access the blade arbor, loosen the flange bolt secur- ing the lower blade guard, slide the bolt up, and pull open the lower blade guard (see Figure 24).

-22-

Scoring

Blade Arbor

Main Blade

Arbor

Figure 24. Main blade arbor components.

5.Place a hex wrench in the hole in the arbor to prevent the arbor from rotating, then use the arbor wrench to remove the arbor nut and arbor flange.

Note: The arbor nut has left-hand threads and loosens by turning clockwise.

6.Slide the blade onto the arbor with the teeth facing the front of the saw (see Figure 25).

Note: Wear heavy leather gloves to pro- tect your hands when installing or removing blades.

Figure 25. Installing the main blade.

7.Re-install the arbor flange and the arbor nut then tighten them against the blade as shown in Figure 25.

8.Close the lower blade guard and secure it closed with the flange bolt.

G0460/G0461 12" Sliding Table Saw