15.Check if the bottom of the rip fence rests on the surface of the table.

Note: The rip fence will scratch the table if the ride height is not adjusted correctly.

—If the rip fence DOES NOT rest on the table, then the fence is correctly adjusted.

—If the rip fence rests on the table, loosen the hex nut shown in Figure 32 and rotate the hex bolt to raise the roller. Tighten the hex nut to lock the height.

Figure 32. Rip fence height adjustment.

G0460/G0461 12" Sliding Table Saw

Riving Knife

To install the riving knife:

1.DISCONNECT SAW FROM POWER!

2.Loosen the riving knife center bolt, slide the riving knife between the plates as shown in Figure 33, and slightly tighten.

Riving Knife

Figure 33. Installing the riving knife.

3.Position the riving knife about 3mm or 18" away from the nearest carbide tooth on the main blade. Note: For a quick gauge, use the 3mm hex wrench to find the correct spacing between the blade and the riving knife, as shown in Figure 34.

Figure 34. Adjusting the riving knife.

4.Tighten the center bolt to secure the riving knife in position.

-25-

Page 27
Image 27
Grizzly G0460/G0461 owner manual Riving Knife, To install the riving knife