Blade Guard

The blade guard can be adjusted along the sup- port rod to help facilitate adjustments made to the blade guide assembly. The blade guard must be adjusted to the lowest position on the sup- port rod before starting the machine.

To move the blade guard:

1.Loosen the hex bolt shown in Figure 9 that secures the blade guard bracket to the guide post.

2.Move the blade guard up prior to making adjustments to the guide bearing assembly, or down, prior to using the machine.

3.Align the slot in the front of the guard with the blade and tighten the hex bolt that secures the it to the guide post.

Figure 10. Blade guard mounting bracket.

Blade Guides

Always adjust the upper and lower blade guides away from the blade before removing, installing or tracking a new blade.

To adjust the blade guides:

1.Loosen the 4 knurled jam nuts (the upper guide assembly is shown in Figure 11) that lock the adjusting knob for the guide bear- ings in place.

2.Rotate the knurled adjuster knob counter- clockwise.

3.Loosen the hex bolt for the back bearing and slide it back. This will allow the blade to be removed or tracked without interference.

4.After the blade tension and the blade track- ing are set correctly, follow the “Guide Bearing” and “Support Bearing” instructions in this section for adjustment details.

Figure 11. Loosen the jam nuts on both sides of the guide block assembly to release the blade guide adjusting knobs.

18" & 20" Super Heavy-Duty Bandsaws

-15-

Page 17
Image 17
Grizzly G0511, G0507, G0506 instruction manual Blade Guard, Blade Guides, To move the blade guard, To adjust the blade guides