Radio Shack XL-110 owner manual ˆTroubleshooting, Adjusting Frequency Crossover

X-OVER FREQ

OVER FREQ

12-2014.fm Page 16 Tuesday, May 9, 2000 8:51 AM

4.Turn up the auto sound system’s volume control until the sound begins to distort. Then immediately turn the volume down to a point just before where the distor- tion began.

Caution: Never turn up the auto sound system’s volume control more than needed to adjust the audio level, or more than two-thirds of its maximum vol- ume.

5.Adjust LEVEL (MIN/MAX) until the sound is at the maximum level you want the amplifier to produce.

6.Adjust the auto sound system’s volume control to a comfortable listening level.

ADJUSTING FREQUENCY CROSSOVER

If you installed a subwoofer using the steps in “Connecting a Subwoofer” on Page 13, set X-OVER FREQ ON/OFF to ON, then adjust X- for your particular vehicle’s acoustics. The amplifier passes through all

frequencies at or below that setting (45−400 Hz).

Note:selects the limit at which the amplifier will pass frequencies (from 45− 400 Hz). You should not use it to adjust the sound you hear through your main speakers.

ˆTroubleshooting

We do not expect you to have any problems with your amplifier, but if you do, these sugges- tions might help.

		Symptom	Possible Cause	Suggestion
	No power — the amplifier’s		Power problem.	Check the amplifier’s and auto-
	POWER indicator does not light			sound system’s fuses and
	after you turn on the vehicle’s			replace them if necessary (see
	auto sound system.			“Replacing a Fuse” on
				Page 18).
			Vehicle’s ignition is not turned	Turn on the ignition.
			on.
			The amplifier is not properly	Check all connections.
			connected to your auto sound
			system/vehicle.
	No sound.		The auto sound system is not	Turn on the auto sound system
			turned on or the volume is set to	or adjust its volume.
			minimum.
			LEVEL (MIN/MAX) is set to	Adjust LEVEL (MIN/MAX).
			minimum.
16			Troubleshooting