Cautions:
•For added safety and to protect your amplifier and auto sound system, dis- connect the cable from your vehicle’s negative (– ) battery terminal before you begin.
•Be sure your speakers can handle as much as 110 watts of power (55 watts
per channel). Each speaker must have an impedance of at least 4 ohms. Your local RadioShack store has a large vari- ety of speakers.
To make it easier to gauge wire length and connect the amplifier, temporarily place the amplifier as close as possible to the selected mounting location.
CONNECTING GROUND AND SWITCHED/PRIMARY POWER
Red
Holder
Fuse
Blue/White
AMP Remote Turn On
Black
Vehicle’s Battery
Chassis
Ground
Switched Power Lead
Auto Sound System
Follow these steps to connect the amplifier to ground, switched power, and primary power.
1.If you have not done so already, discon- nect the cable from your vehicle’s nega- tive (– ) battery terminal.
2.Use a screwdriver to connect the spade end of the supplied black ground wire to the amplifier’s GND (ground) terminal.
3.Connect the black ground wire’s other end to a chassis ground, such as a metal bolt attached to a metal part of the
vehicle’s frame. Be sure the bolt is not insulated from the chassis by a plastic part.
4.Use a screwdriver to connect the spade end of the supplied blue/white wire to the amplifier’s REM (remote power) ter- minal.
5.If your auto sound system has a switched power lead, connect the blue/ white wire’s other end to your auto sound system’s switched power lead
6 | Preparation | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
