SECTION 7: SERVICE
Review the troubleshooting and procedures in this section to fix or adjust your machine if a problem devel- ops. If you need replacement parts or you are unsure of your repair skills, then feel free to call our Technical Support at (570)
Troubleshooting
Symptom | Possible Cause | Possible Solution | |||
|
|
|
|
|
|
Machine | does not | 1. | Break or short in wiring; or loose or corroded | 1. | Trace/replace broken or corroded wires; fix loose |
start or | a breaker |
| connections. |
| connections. |
trips.t |
| 2. | Plug or receptacle is corroded or miswired. | 2. | Correct the wiring. |
|
| ||||
|
| 3. | Power supply switched off/has incorrect | 3. | Switch power supply on/verify voltage. |
|
|
| voltage. |
|
|
|
| 4. | Motor connection wired incorrectly. | 4. | Wire motor correctly. Refer to inside junction box |
|
|
|
|
| cover or Page 54. |
|
|
|
| 5. | Test all legs for power, test field coil, and fix contacts |
|
| 5. | Contactor has poor contacts or is at fault. |
| or replace if at fault. |
|
|
|
| 6. | Replace/reset fuse or circuit breaker. Repair possible |
|
| 6. | Blown fuse/tripped circuit breaker. |
| short or circuit overload. |
|
|
|
| 7. | Replace switch. |
|
| 7. | Motor ON/OFF switch at fault. | 8. | Test/replace if at fault. |
|
| 8. | Start capacitor has blown. | 9. | Adjust/replace centrifugal switch. |
|
| 9. | Centrifugal switch at fault. | 10. Test for shorted windings or bad bearings; repair or | |
|
| 10. Motor at fault. |
| replace. | |
|
|
|
|
| |
Main motor chatters | 1. | Power supply has incorrect voltage on one | 1. | Contact electrician to check incoming voltage. | |
during startup or |
| or more legs. |
|
| |
during operation. |
|
|
|
| |
|
|
|
|
|
|
Model G0513/G0514 (Mfg. 8/02+) |
