Grizzly G0514X owner manual 7aVYZjYZ, 7ZVgc\h 6YjhibZci, @cjgaZY, @cdW HXgZl, JaaZi

3. ;Vb^a^Vg^oZndjghZa[l^i]i]ZWaVYZ\j^YZXdc"
igdahh]dlc^cFigure 55#
7aVYZ<j^YZ	AViZgVa
7ZVg^c\h	6Y_jhibZci
	GdY8Ve
	HXgZl
@cjgaZY	7ZVg^c\GdiVi^dc
	6Y_jhibZci8Ve
@cdW	HXgZl
Figure 55.7aVYZ\j^YZXdcigdah#

4. AddhZc i]Z XVe hXgZl dc i]Z aViZgVa VY_jhi"

bZci gdY VcY VY_jhi i]Z WaVYZ \j^YZh jci^a

i]ZZY\Zhd[i]ZWZVg^c\hVgZ&$&+WZ]^cYi]Z

WaVYZ\jaaZih!Vh^aajhigViZY^cFigure 56#

Note: The 1/16" spacing is ideal, although with larger blades it may not be possible. In such cases, adjust the guide bearings as far for- ward as possible to the blade gullets, and still maintain the proper support bearing spacing adjustment.

7aVYZ

<jaaZi

Figure 56.AViZgVaVY_jhibZcid[WaVYZ\j^YZh#

"()"

Make sure that the blade teeth will not con- tact the guide bearings when the blade is against the rear support bearing during the cut or the blade teeth will be damaged.

5. I^\]iZc i]Z XVe hXgZl dc i]Z aViZgVa VY_jhi" bZcigdY#

6. AddhZc i]Z WZVg^c\ gdiVi^dc VY_jhibZci XVe hXgZlh#

7. GdiViZ i]Z `cjgaZY `cdW id edh^i^dc i]Z WZVg^c\h%#%%)VlVn[gdbi]ZWaVYZ#Note: 0.004" is approximately the thickness of a dollar bill.

8. I^\]iZci]ZXVehXgZlidadX`i]ZWaVYZ\j^YZ WZVg^c\h^cedh^i^dc#

9. GZeZVii]^hegdXZYjgZ[dgi]ZadlZg\j^YZh#

Whenever changing a blade or adjusting tension and tracking, the upper and lower blade support bearings and guide bearings must be properly adjusted before cutting operations.

<%*&)M$"M'$"M'7$"M(B[\#H^cXZ'$&'