Grizzly G0533 Maintenance, Schedule, Exhaust Fan Motor, Interior Booth Walls, Exhaust Filters

SECTION 5: MAINTENANCE

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.

Schedule

How often you perform maintenance checks depends upon the material type and amount being sprayed. Checking at regular intervals can reduce fire hazards, maintain spray booth efficiency, pre- vent newly painted objects from blemishing, and hinder rust.

Exhaust Fan and

Motor

Do not allow paint overspray to build up on the exhaust fan, as overspray deposits will hinder booth airflow. Remove overspray deposits as soon as possible with heavy-duty paint remover to keep the fan in balance. Remove and clean the fan as needed, but do not hammer or step on the fan, as it could be easily damaged. Always disconnect the machine from the power source, and turn OFF the breaker before accessing the fan compartment.

Never operate the exhaust fan without ducting installed.

Ducting

Do not allow overspray to build up inside duct walls. Remove overspray as soon as possible with heavy-duty paint remover, when it builds up, to prevent a possible fire hazard.

-20-

Air Filter Indicator

Check the air filter indicator fluid level periodically and refill as needed with Dwyer® red gauge oil. Clean the indicator with a soft, damp cloth.

Interior Booth Walls

Do not allow overspray to build up on inner booth walls. Remove overspray deposits as soon as possible to prevent a possible fire hazard. Use a non-ferrous, non-sparking scraper to eliminate the possibility of igniting combustible material. Do not leave heaps of paint sweepings in the booth, as these could also cause a fire hazard.

The following products, which are available from a variety of manufacturers, can make it easier to keep the booth clean: special flame-resistant paper, a pre-coating, or clear peel. Consult the product manufacturer for more information about product installation.

Exhaust Filters

Replace filters when the filter indicator shows they need to be changed.

The following replacement filters are available for the Model G0533:

•H5837, 30 micron first stage filter

•H5838, 10 micron second stage filter

•H5839, 5 micron third stage filter

Immediately remove used filters from the booth. Place them in a safe location far away from the booth, or place in a water-filled metal container to prevent a fire hazard. Disposal varies depending on the type of paint being captured. Consult local authorities for storage and disposal recommen- dations.

Model G0533 (Mfg. Since 3/11)