Grizzly G0555X Inventory, Main Components Figure Qty, Fasteners and Tools not shown Qty

Inventory

After all the parts have been removed from the two boxes, you should have the following items:

Main Components: (Figure 2)		Qty
A.	Stand	1
B.	Bandsaw Unit	1
C.	Trunnion Base	1
D.	Lever Board	1
E.	Miter Gauge	1
F.	Extension Table	1
G.	Main Table	1
H.	Fence Assembly	1
I.	Resaw Fence	1
J.	Front Fence Rail	1
K.	Rear Fence Rail	1
Fasteners and Tools: (not shown)		Qty
•	Rubber Feet (Stand)	4
•	Hex Nuts 3⁄8-16 (Feet/Stand)	8
•	Flat Washers 10mm (Feet/Stand)	8

•Hex Bolts M8-1.25 x 35 (Bandsaw/Stand) . 4

•	Flat Washers 8mm (Bandsaw/Stand)	........	8
•	Lock Washers 8mm (Bandsaw/Stand)		4
•	Hex Nuts M8-1.25 (Bandsaw/Stand)		4
•	Hex Bolts M8-1.25 x 30 (Trunnion Base)...		2
•	Lock Washers 8mm (Trunnion Base)	........	2
•	Hex Bolt M8-1.25 x 80 (Positive Stop)		1
•	Hex Nut M8-1.25 (Positive Stop)		1
•	Spacers (Lever Board)		4
•	Cap Screws M8-1.25 x 60 (Lever Board) ..		4
•	Hex Nuts M8-1.25 (Lever Board)		4
•	Set Screws M8-1.25 x 20 (Lever Board)....		4
•	Cap Screws M6-1 x 25 (Lever Board)		4
•	Lock Washers 6mm (Lever Board)		4
•	Flat Washers 6mm (Lever Board)		4
•	Knobs M10-1.5 (Table)		2
•	Hex Bolts M6-1 x 20 (Front Rail)		2
•	Flat Washers 6mm (Front Rail)		2
•	Lock Washers 6mm (Front Rail)		2
•	Cap Screws M6-1 x 16 (Rear Rails)		2
•	Lock Handle M8-1.25 x 20 (Fence)		1
•	Hex Nut M8-1.25 (Fence)		1
•	Moving Plate (Resaw)		1
•	Lock Handle M8-1.25 x 44 (Resaw)		1
•	Flat Washer 8mm (Resaw)		1
•	Hex Wrenches 3, 4, 5mm	1 Each

If any nonproprietary parts are missing (e.g. a nut or a washer), we will gladly replace them, or for the sake of expediency, replacements can be obtained at your local hardware store.

G0555X 14" Extreme Series Bandsaw

B

A

CD

E

G

F

H

I

J

K

Figure 2. Main components inventory.

NOTICE

Some hardware/fasteners on the inventory list may arrive pre-installed on the machine. Check these locations before assuming that any items from the inventory list are miss- ing.

-11-