17.Fasten the front fence rail to the front of the bandsaw table with the two
Figure 13. Fastening front fence rail to table.
18.Fasten the rear fence rail to the back of the bandsaw with two M6-1 x 16 cap screws.
19.Thread the M8-1.25 hex nut from the hard- ware bag onto the fence handle threads, then thread the fence handle into the fence.
20.Tighten the hex nut (already on the fence handle threads) down to the fence body to keep the fence handle from rotating.
21.Pull the fence handle up and place the fence on the front fence rail as shown in Figure 14.
Figure 14. Installing fence onto rails.
22.Push the fence handle down to lock the fence in position.
23.Insert the lock handle with washer through the hole in the fence and attach the moving plate (Figure 15) on the other side.
24.Slide the resaw fence over the moving plate as shown in Figure 15, center it with your original fence, then lock it in position by tight- ening the lock handle.
Lock Handle |
Moving Plate |
Figure 15. Installing resaw fence.
25.Install a light bulb that is rated for the wired voltage of the machine. The bulb must not exceed 60W.
Using a bulb rated for the incorrect voltage may cause it to shatter near the operator, causing person- al injury. Only use “safety coated" and shatter resis- tant bulbs rated for the voltage of your machine.
G0555X 14" Extreme Series Bandsaw |
