Grizzly owner manual Extension table installed G0555X 14 Extreme Series Bandsaw

9.Attach the lever board to the bandsaw body with the four spacers and four M8-1.25 x 60 cap screws, as shown in Figure 9.

Figure 9. Lever body attached.

10.Thread the four set screws into the lever board from underneath until they are flush with the top of the lever board (Figure 10).

12.Remove the aluminum table insert from the center of the table and remove the table pin from the end of the table slot.

13.Fit the table around the blade and rest the table trunnions on the trunnion base, making sure the trunnion bolts are hanging out of the bottom of the trunnion base.

14.Thread the two M10-1.5 knobs onto the trun- nion bolts hanging through the bottom of the trunnion base, as illustrated in Figure 12.

�����

��������������

�������������

�������������

Figure 10. Set screws installed in lever board.

11.Attach the extension table to the lever board with the four M6-1 x 25 cap screws, four 6mm flat washers, and four 6mm lock washers (Figure 11). Only thread the cap screws in halfway for now (adjustments to the exten- sion table will be made later).

Figure 11. Extension table installed.

G0555X 14" Extreme Series Bandsaw

Figure 12. Table installation on trunnion base.

15.Place the table insert in the center of the table, so it sits flush with the table top sur- face.

16.Insert the pin into the end of the table slot.

-15-