Grizzly G0637, G0638 owner manual Assembly, Upper Stand

Assembly

Upper Stand

1.Use (8) 3⁄8"-16 x 3⁄4" hex bolts, (16) 3⁄8" flat washers, and (8) 3⁄8"-16 lock nuts to connect 2 upper stand legs, 1 upper stand brace, and 1 lower stand brace —only finger tighten the fasteners (see Figure 12).

Note: To make the installation of the fasten- ers easier, use scrap wood to raise the metal components off the floor.

Upper Stand Legs

Upper Stand Brace

Lower Stand Brace

Figure 12. One side of upper stand assembled.

2.Repeat Step 1 to make the other side of the upper stand.

Note: The 5⁄16" fender washers with a larger outside diameter will be used to attach the canister filters in later steps—do not use them for any other assembly.

3.Use (16) 3⁄8"-16 x 3⁄4" hex bolts, (32) 3⁄8" flat washer, and (16) 3⁄8"-16 lock nuts to con- nect the two sides of the upper stand with two upper stand braces and two lower stand braces—only finger tighten the fasteners (see Figure 13).

Figure 13. Upper stand assembled.

4.Place the level across a corner of the lower stand braces and move the upper stand around until that corner is level, then fully tighten all of the fasteners for that corner (see Figure 14).

Figure 14. Level positioned on the upper stand.

5.Repeat Step 4 for the rest of the corners, then set the upper stand assembly aside.

-18- G0637/G0638 Cyclone Dust Collector