Grizzly G0637, G0638 Small Cyclone Funnel and Funnel Port, Dust Collection Drum Assemblies

Small Cyclone Funnel and Funnel Port

1.Apply the 3 x 6 x 2200mm gasket to the larg- er, top end of the small cyclone funnel, then place the cyclone funnel upside down on the floor.

Note: Use a clean covering on the floor to protect the gasket.

2.Apply the 3 x 6 x 736mm gasket to the top of the funnel port and place this upside down on top of the cyclone funnel.

3.Attach the small cyclone funnel and funnel port with (6) 5⁄16"-18 x 11⁄4" hex bolts, (12) 5⁄16" flat washers, and (6) 5⁄16"-18 hex nuts.

4.With assistance, attach this assembly to the bottom of the large cyclone funnel with (9) 5⁄16"-18 x 11⁄4" hex bolts, (18) 5⁄16" flat washers, and (9) 5⁄16"-18 hex nuts (see Figure 31).

Small

Cyclone

Funnel

Funnel

Port

Figure 31. Small cyclone funnel and funnel port

attached.

-24-

Dust Collection Drum Assemblies

1.For each lower collection drum cylinders, attach the casters to the bottom using (4) 3⁄8"- 16 hex nuts, (4) 3⁄8" flat washers, and (4) 3⁄8" lock washers (see Figure 32).

Figure 32. Dust collection drum casters installed.

2.Connect each upper and lower collection drum cylinder with a collection drum clamp and use (1) 5⁄16"-18 x 3" hex bolt and (1) 5⁄16"- 18 hex nut to tighten the clamp (see Figure 33).

Figure 33. Installing drum clamp around dust

collection cylinders.

G0637/G0638 Cyclone Dust Collector