To lubricate the elevation gears:
1.DISCONNECT THE SANDER FROM POWER!
2.Use a 4mm hex wrench to loosen the set screw in the elevation handwheel hub, then remove the handwheel to access the eleva- tion gears, as shown in Figure 30.
Figure 30. Elevation gears (elevation handwheel
removed).
3.Apply a small amount of multi-purpose grease on the gears.
4.Reinstall the handwheel, then move the sanding cabinet through its entire range of movement to evenly distribute the lubricant.
Air Regulator/Filter
The air regulator filters the incoming compressed air and deposits the collected water in the filter reservoir (see Figure 31).
Drain Valve |
Filter Reservoir |
Figure 31. Air regulator filter reservoir and drain
valve.
To empty the filter reservoir, make sure there is incoming air pressure and press the drain valve up. This will release a flow of air and the collected water.
G0644 15" |
