Grizzly G0657, G0658 owner manual Setup, To prepare the lathe

Setup

Before use, the tool rest must be moved out of its shipping position and centers must be inserted. For the Model G0658, installing the outboard turn- ing attachment is an optional step.

To prepare the lathe:

1.Loosen the release lever and rotate the tool rest base away from the lathe bed.

2.Loosen the tool rest lock handle and rotate the tool rest so that it is positioned parallel to the lathe bed (Figure 9).

Tool Rest	Tool Rest
	Lock Handle
	Tool Rest
	Base
	Release
	Lever

Figure 9. Tool rest positioned.

3.Tighten the tool rest lock handle.

4.To insert the centers, refer to Installing/ Removing Spur Center and Installing/ Removing Live Center on Page 21.

G0657/G0658 Benchtop Lathe

To install the outboard turning attachment (Model G0658 only):

1.Insert one of the lock handles through the upper slot in the outboard turning attachment, as shown in Figure 10.

Lock Handle

Outboard Turning

Attachment

Figure 10. Positioning Handle

2.Line up the threaded portion of the handle with one of the holes in the lathe base, then thread the handle into the hole. Do not yet fully tighten the handle.

3.Tilt the outboard turning attachment as nec- essary so the slots line up with the other two holes in the lathe base, then thread in the other two handles.

4.Firmly tighten the handles to secure the out- board turning attachment in position (Figure 11).

Outboard Turning

Attachment

Lock Handles

Figure 11. Outboard Turning Attachment

-15-