Outboard Turning
(G0658 Only)
The Model G0658 is equipped with a detachable outboard turning attachment. This provides addi- tional clearance for a greater variety of turning tasks.
See Setup on Page 12 for instructions on install- ing the outboard turning attachment.
To mount a workpiece to the spindle handweel for outboard turning, see Faceplate Turning on Page 26. The method for attaching a workpiece to the spindle is the same for both turning methods.
To place the tool rest on the outboard turning attachment:
1.DISCONNECT LATHE FROM POWER!
2.Prepare the outboard turning attachment by thoroughly cleaning it to remove debris or buildup.
3.Release the tool rest base release lever so the tool rest moves freely, then position the tool rest so the entire base sits on the lathe bed. This will prevent the tool rest from falling when the lock nut is removed (Figure 31).
Tool Rest Base
Release Lever
Figure 31. Safe tool rest position.
4.Loosen and remove the lock nut and clamp washer from beneath the tool rest base (Figure 32).
Lock Nut
Clamp Washer
Figure 32. Lock nut and clamp washer location
(viewed from beneath).
5.Lift the tool rest from the lathe bed and repo- sition it on the outboard turning attachment so that the clamp shaft protrudes through the gap in the outboard turning attachment (Figure 33).
Outboard Turning | Clamp Shaft |
| |
Attachment |
|
| Clamp Washer |
| Lock Nut |
