Grizzly G0689 Assembly Test Run, To attach the elevation crank assembly, To test run the machine

Assembly Test Run

To attach the elevation crank assembly:

1.Align the flat portion inside the crank bore with the flat portion on the shaft, then place the crank assembly on the elevation shaft.

2.Thread the M6-1 x 20 button head screw with the flat washer through the crank and into the shaft to secure the crank in place, as shown in Figure 6. DO NOT over-tighten.

Screw

& Washer

Crank

Figure 6. Attaching crank.

3.Attach the dust collection bag to the planer dust outlet by sliding the clamp over the mouth of the bag, placing the bag over the dust outlet, then positioning and locking the clamp over both the bag and the outlet, as shown in Figure 7.

Figure 7. Dust collection bag.

-12-

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.

The test run consists of verifying the following:

1)The motor powers up and runs correctly, and

2)the safety disabling key on the switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 24.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

2.Make sure all tools and objects used during setup are cleared away from the machine.

3.Connect the machine to the power source.

4.Verify that the machine is operating correctly by turning the machine ON.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

G0689 13" Planer