SECTION 4: ASSEMBLY

Beginning Assembly

 

Drilling Angle Vise

 

 

 

 

 

 

Most of your G1006/G1007 has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.

TOOLS REQUIRED: You will need a 10mm, 12mm, 14mm and 19mm open end wrenches, and a 2.5mm, 3mm, 4mm and 5mm Allen® wrench.

All die-cut metal parts have a sharp edge (called “flashing”) on them after they are formed. This is generally removed at the factory. Sometimes a bit of flashing might escape inspection and the sharp edge may cause cuts or lacerations when handled. Please examine the edges of all die-cut metal parts and file or sand the edge to remove the flashing before handling.

Mounting

It is recommended that you cut a hole in your stand top to allow access to the under side of the base on the Mill/Drill. This will be necessary for adjusting the Y-plane leadscrew.

Before attempting to use your Mill/Drill, mount it securely to your benchtop or stand. Use the largest bolts possible to secure it to the benchtop.

With the head fully raised, this unit is very top heavy and will tip over if not bolted down. Tipping can cause a pinch or crushing type injury. Secure the base firmly.

The drilling angle vise provided with your Mill/Drill attaches to the table with a table clamping kit.

Table clamping kits are available through the Grizzly Catalog and must be purchased sepa- rately. This table will accept 1/2" bolt clamping kits (G1076).

You can mount the drilling angle vise almost anywhere on the table, and it provides a myriad of uses when drilling.

Do not use the angle vise for milling. It is made strictly for holding materials to be drilled. This vise will not adequately clamp an object safely for a milling oper- ation. There is not enough clamping pressure available and objects may be pulled out or upset in the vise jaws causing cutting tools to break and/or parts to be thrown. Any attempt to perform a milling operation using this vise may result in personal injury.

DO NOT make adjustments while the Mill/Drill is running. Ensure that the switch is off, power is disconnected and moving parts have stopped before making adjust- ments.

-11-

G1006/G1007 Mill/Drill