Drill Chuck/Arbor
Your Mill/Drill has been
To install the drill chuck:
1.Clean the grease off the drill chuck. Pay particular attention to the bore in the drill chuck: it must be free from all grease, oil and debris.
2.Clean any grease, oil or debris off the Jacob’s Taper already installed in your Mill/Drill.
3.Retract the drill chuck jaws fully by turning the body of the drill chuck clockwise.
4.Press the drill chuck onto the Jacob’s Taper. Tap lightly with a rubber mallet to get a good fit. Note: While it may not seem like there is anything keeping the drill chuck in place, the Jacob’s Taper fitting provides a strong bond and will hold the drill chuck tightly.
5.This drill chuck installation is permanent.
Do not try to remove the drill chuck from the Jacob’s Taper.
All types of milling cutters and drill bits are sharp. It is recommended that these not be handled directly. Use paper towels to hold sharp tooling to avoid cuts to your hands. Be careful while handling them and store them in a child safe location.
Fly Cutter/Arbor
Your Mill/Drill comes equipped with a fly cutter that fits on the 1" stub end of the
To install the fly cutter:
1.Clean all grease, oil and debris off the
2.Clean all grease, oil and debris off the fly cutter.
3.Fit the fly cutter onto the stub end of the arbor so the keys on the arbor and the key- ways on the fly cutter come together.
4.Secure the fly cutter to the arbor with the cap screw and washer provided. Tighten with an 8mm Allen® wrench.
5.Install the arbor with fly cutter into the Mill/Drill as described in the section titled
COLLET/ARBOR.
G1006/G1007 Mill/Drill |