Additional Safety Instructions Mill / Drills
1.DO NOT use until unit is completely assem- bled and installed according to instructions.
2.DO NOT use the Mill/Drill until all controls and adjustments are understood.
3.BE SURE drill bit or cutter is securely locked in the chuck or holder.
4.USE recommended speeds and feed rate for cutter or drill accessory and workpiece material.
5.ADJUST table or depth stop to prevent drilling into table work surface.
6.KEEP FLOOR AREA around the Mill/Drill free from oil, tools, and chips.
7.NEVER use your hands to hold workpiece during milling or drilling. Clamp it to work surface or use a vise to secure workpiece and prevent rotation.
8.DO NOT WEAR GLOVES, neckties, or loose fitting clothing. Roll up long sleeves. Tie back long hair. Do not use a rag around a rotating cutter. These could get pulled into the cutter and cause severe injury
9.ALWAYS use a brush to remove chips after the cutter has stopped. Never use a rag to remove chips.
10.NEVER operate Mill/Drill if any part is dam- aged or broken until it is properly repaired or replaced.
11.NEVER place your fingers in a position where drill or cutter could contact them if a part shifts unexpectedly. Serious personal injury could result.
12.NEVER perform layout, assembly, or setup work on the mill while a bit or cutter is rotat- ing.
13.SHUT OFF POWER, remove drill or cutting tool, and clean tool before leaving machine.
Like all power tools, there is danger associated with the Model G1006 and G1007 Milling/Drilling Machines. Accidents are frequently caused by lack of familiarity or failure to pay attention. Use this tool with respect and caution to lessen the possibility of operator injury. If normal safety precautions are overlooked or ignored serious personal injury may occur.
No list of safety guidelines can be com- plete. Every shop environment is different. Always consider safety first, as it applies to your individual working conditions. Use this and other machinery with caution and respect. Failure to do so could result in serious person injury, damage to equipment or poor work results.
G1006/G1007 Mill/Drill |