Table Adjustments
The bandsaw table will tilt left 10° and right 45° from horizontal. When tilting the table to the right, the positive stop adjusting bolt automatically indexes the table perpendicular to the blade.
To tilt the table to the right:
1.Loosen the two trunnion knobs below the table trunnions. See Figure 18 for location.
2.Position the table to the desired angle. Refer to the angle gauge on the front table support trunnion.
3.Tighten the trunnion knobs.
Trunnion Knobs 
Figure 18. Table tilt trunnion knobs.
To tilt the table to the left:
1.Loosen the two trunnion knobs below the table trunnions.
2.Tilt the table to the right enough to gain clearance to the positive stop bolt. Loosen the lock nut, then remove the positive stop bolt.
3.The table will now tilt left to approximately 10°. See Figure 19.
4.When the left tilt operation is complete, rein- stall the positive stop bolt.
-20-
Figure 19. Table tilted left.
To adjust the positive stop so the table will be per- pendicular (90°) to the blade:
1.Loosen two trunnion knobs and the locknut securing the positive stop adjusting bolt.
2.Raise the upper blade guide assembly and place a 6" adjustable square or try-square on the table against the blade. See Figure 20. Adjust the positive stop adjusting bolt so that the table is positioned at a 90° angle to the blade.
3.Secure the trunnion knobs and lock the pos- itive adjusting bolt by tightening the locknut. Ensure that the bolt does not turn while tightening the locknut. Set the angle pointer to zero for future reference.
Figure 20. Squaring table to blade.
Model G1019Z 14" Bandsaw
