Grizzly G5771 owner manual Removing Workpiece, To remove cylindrical workpieces

Removing Workpiece

To remove cylindrical workpieces:

1.Loosen the hex bolt and jam nut that secure the upper roller at the gearbox (Figure 29).

	Upper Roller
Jam Nut
	Bushing Bolt

Figure 29. Hex bolt and jam nut.

2.Slide the removable bushing outward. This will release the upper roller from the stand (Figure 30). Do not yet attempt to remove the upper roller.

Removable Bushing

Released

Figure 30. Removable bushing release.

The components of this machine are very heavy and workpieces can be cumbersome and have sharp edges. Always wear gloves and fully support components and workpieces. Get help if necessary. Failure to do this may result in personal injury.

-20-

3.With the help of an assistant, slide and lift the upper roller out from the base. Remove the workpiece from the upper roller, then place the upper roller back onto the base (Figure 31).

Figure 31. Releasing upper roller.

4.Move the upper roller back into position and slide the removable bushing in to secure the upper roller (Figure 32).

Removable Bushing

Secured

Figure 32. Securing upper roller.

5.Center the roller at the gearbox end and thread the hex bolt back into the upper roller bushing. Then, tighten the jam nut against the base to lock the hex bolt in place.

G5771 50" Slip Roll 16 Gauge