AssemblyMounting
The Model G5771 comes from the factory almost fully assembled. All that is required to assemble are the crank and handle.
To assemble your machine:
1.. Thread the crank handle into the small end of the crank and tighten, as shown in Figure 6.
Crank Handle
Crank
Figure 6. Crank assembly.
2.Slide the crank onto the crank shaft until the crank stops against the beveled shoulders of the shaft. Tighten the set screw to secure the crank in place (Figure 7).
Set Screw
Crank
Crank Shaft
Figure 7. Crank mounting.
Once you have confirmed that your machine is assembled and functioning properly, mount it to a workbench through the holes in the base.
The strongest mounting option is a "Through Mount" where holes are drilled all the way through the workbench, and hex bolts, washers, and hex nuts are used to secure the slip roll to the workbench.
7dai |
;aViLVh]Zg |
7ORKBENCH |
;aViLVh]Zg |
AdX`LVh]Zg |
=ZmCji |
Figure 8. Example of a through mount setup.
Another option for mounting is a "Direct Mount" where the machine is simply secured to the work- bench with a lag screw.
AV\HXgZl
;aViLVh]Zg
7ORKBENCH
