ASSEMBLY
Remove the table saw base, loose parts, and hardware from the packing materials. Check all items with the loose parts list and drawing. If you are unsure about the description of any part, refer to the drawing. If any parts are missing, delay assembling until you have obtained the missing part(s).
ASSEMBLING WHEELS AND HUB CAPS
See Figures 7 and 8.
Remove the following hardware from the bag:
2 wheels
2 hub caps
4 flat washers
2 shoulder bolts
Place the table saw on end. Secure the axle in place by inserting a screwdriver or large nail in the hole in the center of the axle. See Figure 7.
Loosen bolts on each side of the axle by turning counter-
clockwise. | SCREWDRIVER |
Note: To prevent the axle from slipping through the slots | Fig. 7 |
| |
on the table saw, do not remove both bolts at the same |
|
time. |
|
Place a wheel and two washers on the shoulder bolt in the | WHEEL |
following order: washer, wheel, washer |
|
Insert the shoulder bolt, wheel, and washers combination |
|
into the axle. Securely tighten. |
|
Place the hub cap in the holes in the wheel and tap the | SHOULDER |
hub cap into place. | BOLT |
|
Note: The short bolts removed from the axle should be kept for future use if wheels are removed. There must always be bolts in both sides of the axle for safe operation.
ASSEMBLING BUMPERS
See figure 9.
Place saw table on end as shown in figure 9.
Align the holes in the bumper with the holes in the side of the saw.
Securely tighten bumpers in place using the screws.
WASHER
WRENCH
Fig. 8
SCREW
Fig. 9
Page 14
