Ryobi Table Saw manual Opening the LEG Stand

ASSEMBLY

OPENING THE LEG STAND

See Figure 10.

Note: You can also refer to the blue label on the right-hand side of the table saw for setup procedures.

￿Standing to the side of the table saw, use your left hand to pull the leg stand latch towards you. See 1.

￿Once the leg stand is released from the table saw base, ease the legs of the leg stand toward the floor. See 2.

￿ Grasp the grip firmly with your right hand. Keeping your left hand clear of the leg stand, pull the leg stand up until it locks into place. See 3 and 4.

￿ With your left hand firmly on the table tilt handle, grasp the grip with your right hand. See 5.

￿Push the leg stand towards the ground with your right

hand and pull in the same direction with your left hand until the table saw is in an upright position. See 6 and 7.

Fig. 10

Page 15