Beginning Assembly
This section will cover the basic assembly and adjustment instructions needed to begin opera- tion. Complete the assembly in the order provid- ed in this manual and then read the remaining portion of the manual before attempting any type of operation.
Your safety is important! Please follow the warnings below during this entire section:
Loose hair and clothing could get caught in machinery and cause serious personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.
!could occur if you
power source before you have completed the assembly process. DO
NOT connect the machine to the power source until instructed to do so.
Sharp edges on metal parts may cause person- al injury. Examine the edges of all metal parts before handling.
Base Feet
To attach the base feet to the bandsaw:
1.Remove the four knob bolts from the side cover (Figure 5).
!
Figure 5. Removing the side cover knob bolts.
2.Attach the base feet to the bottom of the bandsaw with the M8-1.25 x 25 hex bolts and the M8-1.25 hex nuts (Figure 6). Note—The hex bolts extend up through the bottom of the feet, and through the bottom of the band- saw, where they are secured with the hex nut.
Figure 6. Base foot attached to the bandsaw.
|
|
|
|
|
|
|
|
|
|
|
|
G8976 3 Wheel 12" Bandsaw | |||
