SECTION 5: Operations
Test-Run
Before you put your oscillating spindle sander into use, give it a quick inspection. Before inspecting, ensure that the machine is switched off and disconnected from its power source.
1.Are all fasteners tight?
2.Is the sanding sleeve properly installed and secured?
3.Rotate the spindle slowly by hand. Look and listen for any scraping noises or any- thing that impedes smooth movement. Make appropriate adjustments before attempting to run the machine.
4.If the sander appears to be free of prob- lems that might affect its operation, plug it in to its power source and start the machine. Be sure to keep a finger on the OFF button, just in case of a problem with the machine. Allow to run briefly to allow inspection of spindle rotation.
5.Turn off the machine, disconnect it from its power source, and
Never use the Model G9922 for applications other than those for which it was made. DO NOT overload the machine or use excess force when sanding. Severe personal injury, damage to the machine, or damage to your workpiece could occur.
General Sanding
For general wood sanding, position and secure table, turn the machine on and place workpiece on table. While securely holding workpiece, slowly feed against the spindle and maintain con- stant pressure against the table. Use caution when sanding
Table can be tilted at angles up to 45° to allow sanding of angled edges. Simply loosen the knobs located on either side of the table base and set to desired angle. Always check angle measurement against an adjustable angle finder.
|
|
|
|
|
|
|
|
|
| G9922 Oscillating Spindle Sander | |
|
|
